Discontinued Model
Downloads and support materials maintained here as a courtesy to owners.


MIDI Controllers

What pedals can I use with my Kurzweil instrument?


Switch Pedals

A foot switch pedal from any manufacturer is compatible with our keyboards. Japanese pedals are wired in reverse polarity from American pedals. But all our products check the pedal polarity on power up and reverse themselves if needed, so as long as the pedal is plugged in before you turn on the unit, any pedal will work (be certain to not step on the pedal during power up as this can interfere with the auto-calibration).

In addition, some keyboards use mono jacks for each switch pedal input, whereas other keyboards use a single stereo jack for two pedals.

The PC3 Series, K2 Series, K1 series, PC2 Series, SP2 Series, SP5, PC88, and KME61 use mono jacks for each pedal. The standard single pedal available from Kurzweil is the KP-1.

The SP4, SPS4-8, PC1, SP3X, SP76/88 Series, Rumour/Mangler, Mark ProOneiS, Mark ProTwoiS, RG Series, and Troubador use a single stereo jack for dual pedal units (not sold by Kurzweil). It is still possible to plug a single, mono plug pedal into these units but you will only have access to one of the pedals. If the pedal is plugged in all the way, it will be the Left pedal, and if the plug is pulled out slightly, it will be the right pedal. A stereo (M) to dual-mono (F) “Y” adapter can also be employed to permit the use of two, single pedals.

Continuous Controller Pedals

Our keyboards require a pedal with a TRS 1/4″ connector and 10k linear potentiometer. Most manufacturers EXCEPT Yamaha and Korg make pedals with the same specifications and should work. Yamaha and Korg pedals typically use an exponential potentiometer and therefore will not work correctly. The CC-1 pedal is available from Kurzweil. You can order a pedal through your “local Kurzweil dealer.

CC-1 Wiring Spec

The Control Pedal must be wired to a single stereo (TRS) 1/4″ plug as follows:

  • Wiper to tip connection of 1/4″ plug
  • Top end of resistance element to Ring connection
  • Bottom end of resistance to Sleeve connection



How can I restore my RG100 to its factory defaults? (hard reset)


There is no hard reset procedure for these models other than simply powering the unit off then on.


User Manuals

RG100 Musician’s Guide – 976 KB
Owner’s Manual

RG100se Musician’s Guide – 622 KB
Owner’s Manual


Contact Pre-Sales

Do you have questions you need answered before you buy?

Product Registration

Register your new product with your local distributor.

Contact Distributor Support

Do you have questions about the use or application of your Kurzweil product?

Contact Service/Repair

Needing repair? Need to locate a local authorized service center? obtain parts?

Authorized Repair Facilities

Locate a Kurzweil repair facility near you.