This zipped archive includes version 1.50 of the Objects, saved as .a KOS file. This file must be installed via a Smart Media card, so you need a Smart Media drive connected to your computer in order to copy the files to the Smart Media card. 

If you don't have a way of copying the files to a Smart media card, please download the .MID version of the Objects. The file in that archive can be installed by using MIDI Software.

If you have a choice of installing via either Smart Media or MIDI, we recommend installing via Smart Media, because the installation time will be MUCH shorter.

Separate files for the version 1.50 Operating System are available for download, in .KOS, and .MID formats. You should upgrade to the new OS if you are going to install the new Objects file.

Details on how to update your KSP8 can be found in your Users Guide, starting on page E-1, however, for convenience sake, we have also detailed the upgrade procedure below.


------------------------------------------------------------

Version 1.50 Objects Release Notes

 FXMODS have been added to each chain to allow for default joystick control from the RSP8.
 A new Studio, #15 Wind and Waves has been added. This studio uses internal noise generators to create an effect without any input.

Changes to the operating system are documented in the README file for the OS upgrade.
------------------------------------------------------------

Installing the Objects into your KSP8 via Smart media.


If you are going to be installing the new Boot Block and OS at the same time as you install the new Objects file, please refer to the README file included in the OS download. If you are only installing the Objects, please see below:

1. If you have not already done so, copy the file KSPOB150.KOS to the card.

2. There are two ways to enter the boot block:

Start with the power off on the KSP8 and turn the power switch On. The KSP8 will display a "Please wait..." message for approximately 2 seconds. Press and release the exit key (front panel of the KSP8) while the "Please wait..." message is displayed. The Boot Block Main Menu will appear, and the boot block tests the KSP8's files to make sure they are valid.

Or...

While displaying one of the KSP8's studio-level pages, press the MASTER soft button. Press the Reset soft button on the Master page. Press the Loader soft button. The Boot Block Main Menu will appear

3. Insert the Smart Media Card in the slot on the KSP8 and press Install, then Card.

4. The display now shows the list of files on the card. Select the file KSPOB150.KOS 

5. Press the OK soft button. The boot block will first test each segment of an OS or Object file before loading. If any problem is detected it will report that segment as CORRUPT! 

After installation is complete, you will return to the main Boot Block page, where you can select RUN to run the new system.
