What pedals can I use with my Kurzweil instrument?
A foot switch pedal from any manufacturer is compatible with our keyboards. Japanese pedals are wired in reverse polarity from American pedals. But all our products check the pedal polarity on power up and reverse themselves if needed, so as long as the pedal is plugged in before you turn on the unit, any pedal will work (be certain to not step on the pedal during power up as this can interfere with the auto-calibration).
In addition, some keyboards use mono jacks for each switch pedal input, whereas other keyboards use a single stereo jack for two pedals. The PC3 Series, K2 Series, PC2 Series, SP2 Series, PC88, and KME61 use mono jacks for each pedal. Single Pedals available from Kurzweil include the FS-1 and KFP-1. The KFP-2M, a Dual Pedal with two mono plugs is also available.
The SP4 Series, PC1 series, SP3X, SP76/88 Series, Rumour/Mangler, Mark ProOneiS, Mark ProTwoiS, RG Series, and Troubador use a single stereo jack for two pedals. The KFP-2S is available from Kurzweil. It is still possible to plug a single, mono plug pedal into these units but you will only have access to one of the pedals. If the pedal is plugged in all the way, it will be the Right pedal, and if the plug is pulled out slightly, it will be the Left pedal.
Continuous Controller Pedals
Our keyboards require a pedal with a TRS 1/4" connector and 10k linear potentiometer. Most manufacturers EXCEPT Yamaha and Korg make pedals with the same specifications and should work. Yamaha and Korg pedals typically use an exponential potentiometer and therefore will not work correctly. The CC-1 pedal is available from Kurzweil. You can order a pedal through your local Kurzweil dealer.
CC-1 Wiring Spec
The Control Pedal must be wired to a single stereo (TRS) 1/4" plug as follows:
These connections are shown schematically below:
Need more info? Check out the following links: