KnowledgeBase | PC3X | Troubleshooting

KORE 64 DIMM Change

My KORE 64 DIMM does not look exactly like the DIMM pictured in the installation instructions. How do I install it?


Since its initial release, there was a change in the manufacturing of the KORE 64 DIMM.

Here is how each look:

They are functionally identical.

The installation instructions are essentially the same. The only significant difference is you can ignore the two pairs of extra empty pins at the top/center (these are unused). The only pin jumper to be concerned with is the same 3-pin header (circled in red in the photo below). This is the same as you see depicted in the KORE 64 Installation Guide pg. 5, Fig 2:

The picture above shows how a later version KORE 64 DIMM should look new, out of the box. They all come pre-configured for the PC3K. Original PC3 users will need to change the jumper to pins 2+3.

NOTE: The extra black plastic jumper caps included in the install kit are just extra in case you were to ever lose the original.

Need more info? Check out the following links: